Tugicom

Tugicom

Op deze webpagina treft u een overzicht aan van de producten van de leverancier Tugicom. FMZenders fabriceert en verkoopt deze modules en zenders niet. Via het plaatsen van een bestelling langs deze pagina wordt de order rechtstreeks bij Tugicom geplaatst. FMZenders assisteert Tugicom zodat uw bestelling professioneel vanuit Israel door Tugicom wordt afgehandeld. Daarnaast kunt u via FMZenders al uw vragen normaal in het Nederlands stellen.

1 watt stuurzender / 1 watt exciter

Geen verzendkosten

This FM modulator was built to produce excellent broadcasting quality,
while keeping low price and easy of use.
The 1W output power stage, will keep you clean on the air,

and ready to connect directly to high power amplifers.

Features:
- Phase Locked Loop using MC145170 MOTOROLA High quality PLL
- 1W output power using quality 2n4427 transistor (Motorola or APT)
- Low pass filter to clean undesired harmonics (see spectrum picture)
- Easily choose your frequency LCD and buttons
(option of dipswitch instead of lcd display)
- Ready to connect to a MPX STEREO signal - MPX170S
- 3 separated voltage regulators for steady and quiet operation
- RF-OFF while not Locked to protect your amplifier
- On-board jumper to set pre-emphasis: none/50uS/75uS
- Our VCO is well designed to be stable in all frequency
range even below 12V operation
- This is a preassembled & tested board - NOT a kit.

Output Power

1200mW +/- 15% @ 16VDC

Distortion

0.02%

S.N.R

>80dB

Power Requirements

17-28Vdc 250mA

Harmonic Output

-55dBc

Spurious Output

-87dBc

Broadcast Frequency

100Khz Steps (50Khz on request)

Frequency Stability

+/- 250Hz

Audio Input Level

User defined

Audio Response

20Hz-100kHz

Dimension

2" X 4½"

1110100

Klik hier

1 watt stereo stuurzender met limiter / 1 watt stereo exciter with limiters

Geen verzendkosten (Binnenkort leverbaar, Available soon)

The TX190 is the most advanced exciter available on the market.
Knowledge and experiance of years are combined to a compact board which does it all.
The audio input are balanced XLR, the audio is being limited to keep modulation at safe level.
The stereo encoder uses a DSP technology to perform a cleaner pilot with excellent separation.
RF output is 1W clean RF after a LPF and wideband for 1W + output at any frequency.
The TX190 also includes internal RDS for almost any feature available, including scrolling text, realtime update and much more. This exciter is controlled simply with a LCD and up/down buttons.

Features:
- Phase Locked Loop
- 1W output power using quality 2n4427 transistor (APT)
- Low pass filter to clean undesired harmonics
- Easily choose your frequency LCD and buttons
- Internal stereo encoder with DSP technology
- MPX input, MPX output and MPX loopthrew
- RF-OFF while not Locked to protect your amplifier
- On-board jumper to set pre-emphasis: none/50uS/75uS
- This is a preassembled & tested board NOT a kit.

Output Power

1200mW +/- 15% @ 16VDC

Distortion

0.02%

S.N.R

>80dB

Power Requirements

17-28Vdc 250mA

Harmonic Output

-55dBc

Spurious Output

-87dBc

Broadcast Frequency

100Khz or 50Khz on request

Frequency Stability

+/- 250Hz

Audio Input Level

User defined

Audio Response

20Hz-100kHz

Dimension

2" X 4½"

1110200

Klik hier

25 watt eindtrap / 25 watt power amplifier

Geen verzendkosten

This 25W FM amplifier was built to produce excellent no-tune operation,
while keeping low price and easy of use: just connect the output to an fm antenna, and the input to any 1W exciter, we recommend to connect to our TX180A - FM modulator which drive this amplifier to 25W in the range of 87.5-108Mhz without tuning.

Features:
- 25W output power in the whole FM band 87.5-108Mhz with only 1W input -connects direclty to our exciter - TX180A.
- Broadband no-tune state of the art design based on MRF314.
- Low pass filter for broadcast only where you want to and exceed FCC regualtion regarding harmonics.
- new !! CNC drilled black anodized heatsink - no additional heatsink required, only a fan is recommended for the case, two M5 screws to attach to your case easily.
- Optional adjutable output power 0-25W with on board trimmer or external potentiometer - AMP25WA ONLY.
- For power supply to drive this excellent amplifier see our Switching power-supply: 27V/2.4A with over voltage and undervoltage protection, worldwide operation (110V/220V).

1120100

50 watt eindtrap / 50 watt power amplifier (1 watt input with SWR control)

Geen verzendkosten

This 50W FM amplifier was built to produce excellent no-tune operation, while keeping low price and easy of use: just connect the outputto an fm antenna, and the input to any 1W exciter, we recommend to connect to our TX180A - FM modulator which drive this amplifier to 50W in the range of 87.5-108Mhz without tuning.

Features:
- 50W output power in the whole FM band 87.5-108Mhz with only 1W input -connects direclty to our exciter - TX180A
- Broadband no-tune state of the art design based on MRF173
- Low pass filter for broadcast only where you want to and exceed FCC regualtion regarding harmonics.
- new !! CNC drilled black anodized heatsink - no additional heatsink required, only a fan is recommended for the case, two M5 screws to attach to your case easily.
- Internal protection to reduce output power in case of high VSWR
- For power supply to drive this excellent amplifier see our Switching power-supply: 24V/6.3A with over voltage and undervoltage protection, worldwide operation (110V/220V)

1120200

250 watt eindtrap /250 watt power amplifier (1 watt input with SWR control)

Geen verzendkosten

High quality built & tested 250W amplifier

This 250W FM amplifier was built to produce excellent no-tune opertaion,
while keeping low price and easy of use: just connect the outputto an fm antenna, and the input to any 1W exciter, we recommend to connect to our TX180A - FM modulator which drive this amplifier to over 250W in the range of 87.5-108Mhz without tuning.

Features:
- 250W output with 1W input -connect our exciter-TX180A
To fully drive 250W and display output power or SWR alarm on TX180A LCD display.
- 9 Pole Low pass filter - no harmonics emmision.
- SWR protection - auto shut down
- Thermal protection - auto shut down
- Forward and reflected power sensor - connect any voltage meter/ digital bargraph to display forward/reflected power.
- Broadband no-tune design based on M/A-COM MRF151G and a driver amplifier.
- Heatsink included.

For a complete 250W transmitter add :
TX180A - 1W exciter module
MPX170S- Stereo encoder (if stereo required)
48V 10A Swithcing Power supply
110V/220V fan

Output Power

250W MIN - 300W MAX

Input power

800mW - 1.3W MAX

Spurious Output

-75dBc

Harmonic Output

-65dBc

Rating input power

48V/7.5A DC

Dimensions

6.l" X 4.1" X 14"

1120300

600 watt eindtrap / 600 watt power amplifier (10-15 watt input)

Geen verzendkosten

High quality built & tested 600W amplifier

Our new 600W amplifier is our excellent 87.5-108Mhz no-tune amplifier.
This amplifier is the best choice for every manufacture of FM Broadcast transmitter

Features:
- 600W output with 15W input - can be driven excellent by our 25W amplifier.
- Broadband no-tune design based on M/A-COM MRF151G
- Heatsink included.

For a complete 600W transmitter add :
TX180A - 1W LCD exciter module
MPX170S- Stereo encoder (if stereo required)
48V/20A Swithcing Power supply
110V/220V fan

1120400

1000 watt eindtrap / 1000 watt power amplifier (15 watt input with SWR control)

Geen verzendkosten

Our new 1KW amplifier is our excellent 87.5-108Mhz no-tune amplifier.
This amplifier is the best choice for every manufacture of FM Broadcast transmitter

Features:
- Upto 1.2KW output with 15W input - can be driven excellent by our 25W amplifier.
- Broadband no-tune design based on M/A-COM MRF151G
- Heatsink included.
- Excellent effeciency thanks to output proffesional teflon combiner
- Can be used at lower output power with lower power supply voltage.
- SWR protection and output coupler

Specification
Output Power 1000W MIN 1250W MAX
Input power 15-25W
Operating voltage 48V/40A DC

1120500

Klik hier

Stereocoder

Geen verzendkosten

Our new MPX170S stereo encoder provides excellent stereo seperation
while keeping low price, easy of use, and zero faults.
Just connect 12V-15V, audio input from every CD / Mixer of computer
and connect the MPX output to every MPX ready transmitter

Operation power

12V-15V DC 50mA

Stereo separation

>40db

Pilot

19Khz +/- 3Hz - XTAL

Input impedance

10Kohm

Pre-emphasis

50uS/75uS factory set

Dimension

2" X 2¼"

1130100

Klik hier